Web Installer

Flash OpenShrooly firmware directly from your browser - perfect for first-time installation

⚠️ Your browser doesn't support Web Serial. Try Chrome, Edge, or Opera. ⚠️ Web Serial is not allowed. Please check your browser settings.
⚠️ Important:
  • This will replace your existing Shrooly firmware
  • If you'd like to be able to go back to the factory Shrooly firmware, make sure to backup your original firmware first
  • Installation is at your own risk
💡 Already running OpenShrooly?

If you're currently running an older version of OpenShrooly, use the OTA (Over-The-Air) update feature instead to preserve your WiFi settings and device configuration:

  1. Access your device's web interface
  2. Find the "OTA Update" section
  3. Upload the .ota.bin file from the releases page

Use this web installer only for: First-time OpenShrooly installation or when you want to completely reset your device.

Installation Steps:

  1. Select your desired firmware version above
  2. Connect your Shrooly device via USB
  3. Click "Install OpenShrooly"
  4. Select your device's serial port when prompted
  5. Wait for the installation to complete (about 2-3 minutes)
  6. After installation: Complete device setup - configure WiFi and access your device

Device Requirements:

  • Shrooly device with ESP32-S3
  • USB cable (data cable, not charge-only)
  • Chrome, Edge, or Opera browser (desktop)

Need Help?